SC-914 Primaset is a slow-cure, 20% solids, polyurethane primer containing a solvent called Xylene. SC-914 is a single component product. This material should be warm, not hot, during application for best results. CAUTION - This material is flammable!
SC-914 Primaset has been designed for use as a thin film sealer/primer. It is not intended to be applied as a coating, rather its purpose is to absorb into and completely saturate the surface of any porous substrate, such as wood, concrete or fiberglass. The high rate of absorption into a substrate is due to the ultra low viscosity of the product itself. When used in this manner, SC-914 chemically converts the substrate into a surface with the chemical composition of urethane. This enhances the adhesion of subsequent coatings by adding chemical adhesion to any already existing mechanical adhesion.
Additionally SC-914 acts as a sealer, displacing air molecules from voids in the surface of a porous substrate, thus reducing pin-holing. Once SC-914 gels, transmission of vapor (both air and moisture) through the surface of the substrate from below is greatly reduced, further reducing pin-holing. SC-914 may also be used as an adhesive between old and newly applied coatings. When using SC-914 over old, especially UV damaged coatings such as epoxies, polyurethanes or polyureas, SC-907 ReactiSolve may be required as an additional primer which must be applied before SC-914. SC-907 ReactiSolve temporarily reactivates old coatings in preparation for other primers with longer open times.
For technical documents such as MSDS, TDS, installation guides, spec writing tools, case studies and performance reports contact us or login at My SprayBuilt Account. If you have not yet activated My SprayBuilt® Account to access these online resources please contact us or your local technical representative for the necessary information to get started.